Installing the satellite dish
What to make installing the antenna you will need: the antenna itself (included with it comes with a bracket that allows you to make a fastening to the wall). Convector – a head that stands directly in front of the dish and allows you to receive the signal, antenna cable with an impedance of 75 ohms, the tuner, which allows you to play a signal directly on the TV screen. Sockets, screws with dowels and tool kit. Carrying out renovation of the apartments, also establish a satellite dish.
Before installing, decide on the place where the antenna will be located. Windows must be on the south side, otherwise – installation can only be done on the roof. Then fix the bracket on the wall and hang the assembled antenna with the convector. Then tune your receiver, for this you need to prescribe the transponder of an open channel. Next, connect the convector to the receiver, with a cable and start turning the dish in different directions. When you have found the right tone, in this position, tighten the nuts, the cable receiver connect to the convector, make the cable ties and read the instructions to the receiver. At the end of the installation, tune the channels according to the instructions.